I'm having a hard time figuring out how to go about this.I have the correct measurements for the first lot but as someone stated [depending on what strength is needed for the area.]
Measurement is M6X1.0X2.75 but PB only go to 25mm or 30mm.
Would normal Aluminium be fine?
http://www.probolt-australia.com/alu...-x-10-red.html
![]()
![]()
Yes the bike will be getting cleaned tomorrow.
Much appreciated,Jamie.
Measurement is M6X1.0X2.75 but PB only go to 25mm or 30mm.
Would normal Aluminium be fine?
http://www.probolt-australia.com/alu...-x-10-red.html
Yes the bike will be getting cleaned tomorrow.
Much appreciated,Jamie.